| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
If connect fails with any other error than EINPROGRESS we cannot get
the error status using getsockopt (... SO_ERROR ... ). Hence we need
to remember the state of connect and take appropriate action in the
event_handler for the same.
As an added note, a event can come where poll_err is HUP and we have
poll_in as well (i.e some status was written to the socket), so for
such cases we need to finish the connect, process the data and then
the poll_err as is the case in the current code.
Special thanks to Kaushal M & Raghavendra G for figuring out the issue.
Change-Id: Ic45ad59ff8ab1d0a9d2cab2c924ad940b9d38528
BUG: 1372356
Signed-off-by: Atin Mukherjee <amukherj@redhat.com>
Signed-off-by: Shyam <srangana@redhat.com>
Reviewed-on: http://review.gluster.org/15440
Smoke: Gluster Build System <jenkins@build.gluster.org>
NetBSD-regression: NetBSD Build System <jenkins@build.gluster.org>
CentOS-regression: Gluster Build System <jenkins@build.gluster.org>
Reviewed-by: Raghavendra G <rgowdapp@redhat.com>
|
|
|
Earlier, both chagelog on/off and brick restart were considered
to be changelog breakage and treated as changelog not being
continuous. As a result, new HTIME.TSTAMP file was created on
both the above cases. Now the change is made such that only
on changelog enable/disable, the changelog is considered to be
discontinuous. New HTIME.TSTAMP file is not created on brick
restart, the changelogs files are appended to last HTIME.TSTAMP
file.
Treating changelog as continuous in above scenario is important
as changelog history API will fail otherwise. It can successfully
get changes between start and end timestamps only when changelog
is continuous (Changelogs in single HTIME.TSTAMP file are treated
as continuous). Without this change, changelog history API would
fail, and it would become necessary to fallback to other mechanisms
like xsync FSCrawl in case geo-rep to detect changes in this time
window. But Xsync FSCrawl would not be applicable to other
consumers like glusterfind.
Rationale:
1. In plain distributed volume, if brick goes down, no I/O can
happen onto the brick. Hence changelog is intact with data
on disk.
2. In distributed replicate volume, if brick goes down, since
self-heal traffic is captured in changelog. Eventually,
I/O happened whend brick down is captured in changelog.
Change-Id: I2eb66efe6ee9a9228fb1fcb38d6e7696b9559d5b
BUG: 1211327
Signed-off-by: Kotresh HR <khiremat@redhat.com>
Reviewed-on: http://review.gluster.org/10222
Reviewed-by: Venky Shankar <vshankar@redhat.com>
Tested-by: Venky Shankar <vshankar@redhat.com>
Tested-by: Gluster Build System <jenkins@build.gluster.com>
Tested-by: NetBSD Build System
|
